Step-by-step instructions to gluing inner corners

After finishing, the principal problem can gidpola.ru be uneven walls and the resulting springs on the background. It is also crucial to take into consideration that when the walls are crookedthe joints of wallpaper canvases could invisibly.

After gluing the last one in front of the interior corner of the cloth should measure the remaining distance. It is measured from the border of the glued cloth to the adjacent wall, so the resulting figure is inserted 10-15 millimeters. When the walls are extremely curved, the further figure could be more.

Cut a strip equivalent to the resulting figure, taking into account the allowance. The surfaces are treated with glue. Based on the type of coating it could be just the wall or both surfaces.

The strip is then glued individually using the cut side to the wall. The background should go on the opposite airplane.

In case the glued wallpaper is sterile, then you will need to make several little cuts perpendicular to the folds.

Level or slope on the adjoining wall is a perpendicular line. The distance in the corner is equivalent to the width of the prior cut strip, not adding developments.

The surfaces are smeared with adhesive, and the coat is glued into the wall using the flat side into the line. The cut goes onto the adjoining wall.

The best way to paste the outer corner (outer corner)?

Protruding corner ought to be glued by analogy using the inner, but there are little gaps, which also need to be taken into account when working.

Measured the space remaining from the glued background to the adjacent wall. Add 20-25 millimeters to the figure.

A segment is cut off, considering the added 20-25 millimeters.

Before gluing, the surfaces have been treated with adhesive.

The even edge must be glued into the wallpaper fixed on the walls, the own cut side”goes” to the adjacent plane. If needed, small cuts are created in the area of going to the other wallpaper, smoothed and pushed into the wallsocket.

Draw a vertical strip onto the adjoining wall in a distance of just glued cut strip plus 6-10 millimeters.

After applying the glue, the strip is applied to the wall using its flat side towards the line, going over the edge of this glued strip.

The joints have been smeared with adhesive and ironed with a roller. Following that, the upper layer is trimmed along the ruler and the two layers are combined together.